User Manual

To carry the machine, grip it below the edge of the housing.
3.3 Erection
 Lift the instrument with the transport pallet.
Do not walk below the transport pallet.
 The instrument is attached to the transport pallet without screws.
 Lift the instrument off the transport pallet.
 Place the instrument on a level, stable surface, indoors. It is not necessary to fasten the
instrument on the erection site. The instrument can also be mounted on a sturdy table.
It is inadvisable to operate the instrument while it is standing on the transport pallet.
 Ensure that there is good access to the instrument. There must be enough space to reach
the main switch.
 Do not block the exit of air from the ventilator louver at the side. There is a danger of
overheating if the louver is blocked.
3.4 Ambience conditions
 Use the instrument only inside.
 The air must not contain any electrical conductive dust.
 The ambient temperature must be between 5 and 40°C.
 Height up to 2000m M.S.L.
 Maximum relative humidity of air 80% temperature up to 31
o
C, linear de-creasing
down to 50% relative humidity of air at 40
o
C
 Contamination level 2 (IEC 664)
3.5 Electrical Connection
Before making the connection, compare the voltage and current values shown on the
nameplate with the values of the mains supply to which the instrument is to be connected.
Single-phase alternating voltage with protective conductor (see section 1.4 Technical Data).
Electrical Safeguard!
Danger of damages due to short-circuit.
Ensure that the socket is connected to a power line secured with a circuit
breaker.
Non-observance of the values on the type plate may damage electrical as well
as mechanical components.