User Manual

Mains Voltage!
The connector may only be altered by a trained expert.
3.6 Switching On for the First Time / Test for Correct Functioning
Switch on the machine only when all the work described in section 3 Installation has been
done.
Switching On
1. Connect the machine to the mains supply.
2. Switch on the machine with the main switch at the top of the machine.
3. POWER SUPPLY shines
4. Open the hood.
5. There should be nothing in the grinding jar holder.
6. Close the hood.
7. Turn on the Emergency stop clockwise.
8. Press RUN on the control panel.
9. The mill will run at the preselected speed.
Switching Off
 Press STOP on the control panel.
 After a short period (after the mill has come to a standstill), open the hood.
4 Working with the mill
Warning!!!
Before starting the machine, ensure that the grinding jar is correctly braced and there are no
loose parts inside the device. There is a risk that loose grinding jars or parts will be thrown
out.
If this instruction is not observed, no guarantee or claims will be accepted for damages to
the device or injuries to persons.
Caution!!!
The grinding tools are subject to normal wear. Prior to each comminution the thickness of
the grinding jar wall is to be inspected. With severe wear the grinding jar is to be changed. If
not, the possibility exists that the grinding ball due to high centrifugal forces which occur
during the grinding may strike through the grinding jar wall, damaging the mill. We don’t