User Manual

 Switch the Emergency Stop clockwise.
 Press the RUN button on the control panel.
 The mill will run.
 The mill will rotate at the speed set – if the load is too great, e.g. if the grinding jar is
too large, the machine will be run at a lower speed so as to prevent overloading.
4.8.1 Overloading
In the event of overloading of the mill, the speed will be reduced.
4.8.2 Miscellaneous
During operation, the hood must remain closed even during the breaks, and the fan will run.
4.8.3 Switching Off
 Press STOP on the control panel.
 When the drive has come to a standstill, the hood can be opened.
 Switch off the main switch at the top of the machine if the machine is to be inoperative
for an extended period.
4.9 Cooling the Grinding Jars
 with the hood open or
 at the programmed break times with the hood closed and the ventilator
running.
5 Cleaning
5.1 Grinding accessories
 Clean the grinding jar and grinding balls after each use: e.g. brush them clean under
running water with usual cleaning agents.
 Fill the grinding jar with grinding balls and some sand and water half-full and run the
planetary mill for 2 to 3 minutes (with the grinding jar correctly clamped in position).
 Cleaning in the ultrasonic bath is permissible.