User Manual

 When sterilizing the grinding jars and grinding balls in the heat cabinet, heat only to
100°C.
Parts of agate, sintered corundum, zirconium oxide should being cooled down carefully
and slowly.
Agate parts must never be heated in the microwave (they heat up too rapidly).
They must never be subjected to temperature shocks, such shocks may destroy the parts
→
They burst apart explosively.
5.2 Mill
 When switched off, the mill can be wiped down with a damp cloth.
Do not allow any liquids to seep into the machine.
6 Maintenance
Before commencing maintenance work, disconnect the mains plug and secure the machine
against being switched on again unintentionally.
When maintenance work is being performed, this should be indicated with a warning sign.
Regular cleaning is the most important part of maintenance.
Functional part
Task /
Description
Test
Maintenance
interval
Gears
Permanent
lubrication
Bearing play
Every month
Drive motor
Permanent
lubrication
Bearing play
Every 4,000 hours
or annually
Belt
Motor planet
disk
Check the tension
Disconnect the mains plug, pull
down the mill; the belt should
not yield by more than approx.
10 mm under thumb pressure.
1 x annually
Fan
Cooling the
grinding
chamber and
electronics
Operation: clean when dirty
2 x annually
Grinding jar
sealing gasket
grinding jar lid
seal
If dirt pressed in the sealing,
replace it!
Every 100 hours