Installation Manual

Part Number 3080006.001, Rev. D ©2012, HES, Inc. 5
Install
9
Install the antenna/reader.
9a. Place and hold the antenna/reader to
the outside of cabinet, routing the
wire through the 1/2” offset hole.
9b. Install the washer and top screw,
which attach the antenna/reader to
the outside case.
Refer to the table below to determine
the length of the top mount screw
needed, based on the thickness
of the cabinet door.
WARNING!
Make sure you avoid crimping the
wires. Crimped wires may prevent the
Reader and Lock from functioning.
Table 2.
10
Install the lock.
10a. Remove the battery cover from lock. Place the lock on the inside of the door, threading the cable
through the lock.
10b. Using two 6-32 lock mount screws (see table 2 for length), attach the lock to the antenna/reader.
Tighten the screws.
Reader mounting.
Washer and screw.
9a.
9b.
Thread the cable
through the hole
in the lock.
10a. Place the lock and thread cable.
10b. Attach the lock to the antenna reader.
Table 2