User's Guide

13. Electrically connect the antenna/reader wire to the lock body.

Make sure to correctly orient connector while inserting it. The connector is keyed to only fit one way.

14. Install the Batteries.

14a. Gently tuck the wires into the battery cavity.

14b. Install the battery and battery cover.

Note: Please verify the battery is inserted in the correct polarity position.

14c. Install and tighten the screws.

Note: Always use new batteries installed with correct polarity.

15. Place the single-door Strike Plate Template.

15a. Peel off the protective layer of the Strike

Plate Template and align it to both the

latch centerline and the edge of cabinet.

15b. Drill two pilot holes as shown on template.

15c. Remove the template.

14a

14b

14c