User's Guide

3080076.002, Rev. X01 Draft ©2013, HES, Inc. 7
. Transfer the location of the inside wall of the cabinet to the door.
6a. Measure the horizontal distance between the inside edge of the cabinet and the door edge.
6b. Using the same distance away from the door edge, draw a line on the outside surface of the door.
This line depicts the location of the strike mounting surface.
7. Place and use the Lock/Reader Template.
*note orientation may be reversed for right hand door
7a. Cut through line to separate the Strike Plate
Template.
7b. Peel off the protective layer of the Lock Template
and align to both the latch centerline and the line
depicting the inside wall of cabinet. Press to
secure.
7c. Drill four holes and two pilot holes through the
cabinet, as shown. Two holes are 3/16”
diameter and two are 1/2” diameter.
7d. Drill only one 3/16” hole depending on the
desired antenna/reader orientation.
Refer to step 10 if you are installing the
optional Key Override.
7e. Remove the lock template from the door.
Cabinet/door front view
when
Door edge
6a
6b
7a
7b, 7c, 7d
A
B
C