User's Manual

Part Number 3085006.001, Rev. A 6

4. INSTALL the shaft extension.

a. IF the cabinet door thickness is greater than ½” [12.70 mm] (see Table 1),

THEN INSTALL the Shaft Extension to the Antenna/Reader to ensure proper engagement into the lock.

b. INSTALL the Shaft Extension to the shaft as shown in the figure, and firmly TIGHTEN the screw.

Table 1

Door Thickness Extension Shaft Used?

1/16” [1.59 mm] – ½” [12.70 mm] No

> ½” [12.70 mm] – 1 ½” [38.10 mm] Yes

5. IF a Cam Lock key override will be used,

AND the orientation allows for installation,

THEN INSTALL the Key Override Paddle.

a. INSERT the paddle’s arm into the opening shown, and ALIGN the rails of the paddle to the ones on the lock.

b. SLIDE the paddle gently until it stops.

PREPARE the Key Override Door.

NOTE: The Cam Lock is optional and must be obtained by others.

a. IF a Key Override is used,

THEN MARK and DRILL a hole for a 3/4” [19.05 mm] Cam Lock in the door using the template as a guide.

b. INSTALL the optional Cam Lock with the Cabinet Lock as shown in the figure.