User's Manual



3080076.004, Rev. C 14

DRAFT

8. INSTALL the lock.

8a. REMOVE the battery cover from lock.

8b. PLACE the lock on the inside of the door, threading the cable through the lock.

8b. ATTACH the lock to the antenna/reader using two 8-32 [4.00 mm] lock mount screws

(see Table 2 for length), and TIGHTEN the screws.

8c. INSTALL the two #6 self-threading screws and TIGHTEN.

NOTE: The third #6 self-threading screw is important to

achieve maximum holding force for doors greater

than 5/8” [15.88 mm] thick.

8d. INSTALL the third #6 self-threading screw only if the door

is more than 5/8” [15.88 mm] thick, using the lock as a

guide, and TIGHTEN.

9. Electrically CONNECT the antenna/reader wire to the lock body.

NOTE: The antenna/reader wire connector is keyed to only fit one way.

9a. ENSURE correct orientation of the connector while inserting it.

9b. TUCK excess cable into lock body as shown.



Connector cable tucked in

Cable is threaded

through the hole

in the lock.

Used only

for doors less

than 5/8” thick.