User's Manual


3080076.004, Rev. C 15
DRAFT
10. INSTALL the Batteries.
NOTE: New batteries should always be used and inserted in the
correct polarity position.
10a. INSTALL the battery and battery cover.
10b. INSTALL and TIGHTEN the screws.
11. PLACE the single-door Strike Plate Template.
11a. PEEL OFF the protective layer of the Strike Plate Template
and ALIGN it to both the latch centerline and the edge of
cabinet.
11b. DRILL two pilot holes as shown on template.
11c. REMOVE the template.
***CAUTION***
The Installer must ensure the lock can be opened before closing the cabinet.
12. INSTALL the single-door strike plate.
12a. PLACE the strike plate over the pilot holes, and INSERT and TIGHTEN the two screws in the slotted holes.
12b. CLOSE the door to verify installation, and ADJUST the strike plate if necessary.
12d. INSERT and TIGHTEN the lock down screw on the strike plate.
10a
10b 

12a–c
12d