User's Manual


Part Number 3080006.009 Rev. C 6
DRAFT
6. Installing the lock on the door
1. SLIDE lock into cutout.
PLUG 48V PoE RJ-45
cable into lock. Lock
will beep once and
perform self test.
3. Optional: The DPS signal is closed when the handle is resting in
its locked position. The DPS circuit can be extended to include
normally open DPS switches arranged in a series to monitor
additional doors and panels.
4. ATTACH rear bracket with screws.
DPS Extension Cable
DPS
Switches
(SPST-
NO): As
Needed
Switch #1
(SPST-NO):
Provided
Extending the DPS Circuit:
A: REMOVE the DPS jumper.
B: CONNECT the included DPS
extension cable
C: CONNECT additional normally
open DPS switches as shown to
monitor additional panels.
24VDC cable
A
B
5. ENSURE that the lock is fully secured
and flush to the mounting surface in
order to depress tamper switch on
back of device for correct operation.
Tamper Switch
NOTE: If the tamper switch is not
fully depressed, you will
see a flashing red light
and the device will not
read cards.
2. SELECT Power source: (A. 24VDC Supply or
B. 48V PoE)
CONNECT 24 VDC cable
to lock.
CONNECT 24 VDC power
supply (not provided) to
24 VDC cable.
Red wire (24VDC), black
wire (Ground)