User's Manual



500-24050, Rev. B 3

DRAFT

Prepare the R100

1. Before starting, MARK the position using a level.

2. HOLD the reader body on the outside of the window and POSITION it generally where you would like

it to mount.

Insert Battery

INSTALL the battery, ensuring correct orientation.

VERIFY the reader self tests and beeps once.

Mount the Unit

NOTE 1: The R100 can be mounted using glue or wood screws based on your needs.

NOTE 2:

This following step allows oxygen to enter and aid in the curing process.

1. IF the R100 is mounted using glue,

THEN APPLY glue as a thin thread of glue applied to three sides of the back-plate as shown,

AND DO NOT USE tissue or a brush to spread the adhesive.

NOTE 1: The seal becomes functional within a short time and permanent after 24–72 hours.

NOTE 2: The rate of cure depends on the ambient relative humidity. The best results are achieved

when the relative humidity in the working environment is 40–60% at 22˚C. Lower humidity

leads to a slower cure. High humidity accelerates it, but may impair the final strength of the

bond.

2. Quickly AFFIX to the pre-marked area and HOLD or CLAMP until the adhesive has bonded (at least

five seconds).

Position

mark

Glue line

Battery

A pencil is used to mark

this

oint on the window

The cover is

pulled up while

pressing on the

LED