User's Manual


500-24050, Rev. B 4
DRAFT
3. PERFORM the following if the R100 is mounted using wood screws.
a. SEPARATE the components by gripping the electronic module at the noted side areas.
b. ROCK UP, PULL DOWN, and LIFT OUT.
c. PRE-DRILL through the mounting plate at the four corners and INSERT wood screws.
d. REATTACH electronic module by sliding the top under the mounting plate’s raised edges and
PRESS DOWN firmly until it clicks.
Test the Reader
1. REATTACH cover and INSERT screw with the included hex wrench.
NOTE: A green LED indicates access is granted.
2. USE a credential known to the access control system to confirm it will read as desired.
3. REFER to the LED reference card for any other codes.
Optional: Attach Dress Cover
1. INSTALL a separately purchased dress cover (R100-DCA) on the inside of a glass mounting surface.
2. PEEL the backing from the adhesive on the cover and AFFIX to the window.
Cover
Screw
Dress Cover
R100 (rear view)
Side grip
areas
Mounting
Plate
Wood screws