Area Imager Cordless System System Manual IMAGETEAMTM 2020/4620

IMAGETEAM™ 2020/4620 System Manual 2 - 1

Programming the Interface

Introduction

Chapter 1 describes connecting the base to the computer with the appropriate

interface cable. This chapter describes how to program your system for the

desired interface.

Plug and Play

Plug and Play bar codes provide instant imager set up for commonly used

interfaces.

Note: After you scan one of the codes, power cycle the host terminal to have the

interface in effect.

Keyboard Wedge Connection

If you want your system programmed for an IBM PC AT and compatibles

keyboard wedge interface with a USA keyboard, scan the bar code below.

Keyboard wedge is the default interface.

Note: The following bar code also programs a carriage return (CR) suffix.

Laptop Direct Connect

For most laptops, scanning the Laptop Direct Connect bar code allows

operation of the imager in parallel with the integral keyboard. The following

Laptop Direct Connect bar code selects terminal ID 03, programs a carriage

return (CR) suffix and turns on Emulate External Keyboard (page 2-14).

IBM PC AT and Compatibles

with CR suffix

Laptop Direct Connect

with CR suffix