Scanner User Manual

Terminal Setup
24. Click on OK.
25. Cold boot the terminal.
26. Click
Enter.
27. Select the
Specify an IP Address button.
28. Enter the IP Address, Subnet Mask, and Default Gateway.
29. Click on OK.
30. Go to Start, Programs, Cisco, and Client Utility.
31. Select SSID and its Value.
32. Click on OK.
33. Go to Start, Programs, Cisco, and Client Utili
34. Select World Mode, and change the Value to Disabled.
35. Click on OK.
36. Warm boot the terminal. To perform a warm boot, press and hold the CTRL and SFT
keys for about 10 seconds, then release.
ty.
2-56 Supported Equipment Manual • January, 2006