SZT Linux 數位監控系統 使用說明手冊 Installation Guide 1
PC Requirement 4/8 channel CPU Motherboard 12/16 channel Dual Core E1200 or above E2180 / E2200 or above -- Gigabyte -- or -- Asus-- Intel 945, 965, P31, G31 chipset ※ ASUS need to install network driver manually RAM 512 MB 1GB VGA GIGABYTE / ASUS (NVIDIA chipset) 7200GS, 7300GS 64 bit above ※Not support ATI chipset VGA. GIGABYTE / ASUS (NVIDIA chipset ) 6600, 7300GT, 7600 128MB/128bit above ※Not support ATI chipset VGA.
Chapter 1: HDD Installation Important Note Insert hard disk with the interface slot in order from symbol SATAll0 → SATAll1 → SATAll2 → SATAll3 on the motherboard. Chapter 2: Press “Delete” right after the rebooting to enter the BIOS setting (1) Enter “Advanced BIOS Features” and select “CDROM” to be first boot device, “Hard Disk” to be second boot device. (2) Enter” Integrated Peripherals” and Set “On-Chip SATA Mode” as “Enhanced”.
SkyView Linux-DVR installation steps Step1： At beginning, select “Installation” and key in “autoyast=file:///eng.xml” below at “Boot Options” and press” Enter” for automatic installing Linux O.S and configurations setup. (1st hard disk will automatically partition; 2nd hard disk above need to partition manually; Please refer to CD user manual for more information) Select: “Installation” Key in “autoyast=file:///eng.xml” Select “Boot from Hard Disk” After key in “autoyast=file:///eng.
Rebooting the computer Click Step2: → Select “Leave ” → Select “Restart Computer” → Click “Confirm” SkyView software and drivers installation (Do not take Linux DVR CD out in order to run installation continually) 1. Click “Boot from Hard Disk” Select “Boot from Hard Disk” 2. Select “Failsafe --openSUSE 10.3 DVR” within 8 seconds Select “Failsafe --openSUSE 10.
Key in the following command for installing SkyView applications and driver a. Linux login : Key in “root” and press “Enter” b. Password : Key in “1qaz2wsx” (1, 2 are numerals) and press “Enter”, if enter correct password will appear ” have a lot of fun ” ; ( Write in small letter and password will be invisible ) c. Linux : ~# mkdir□ /media/linuxdvr ( □ stands for “spacebar”) d.
During the installation, do not press any key until below page appear The installing of audio driver will appear five screens; click “OK” or “YES” only Wait one minute after click “YES” on last screen, and then choose signal format type or NTSC format : key in “1”; PAL format : key in “2”; then press “Enter” Complete key in 1 or 2 format, computer will automatically reboot and then take CD out. DVR Main screen will automatically appear and log out the DVR program first for setting network and date time.
