User's Manual

11 - 3

Test Menu

When you scan the Test Menu

code, then scan a programming code in this

manual, the imager displays the content of a programming code. The program-

ming function will still occur, but in addition, the content of that programming

code is output to the terminal.

Note: This feature should not be used during normal imager operation.

2D PQA (Print Quality Assessment)

Two-dimensional Print Quality Assessment (2D PQA) is a feature of Honeywell’

image readers where the data from the successful read of a 2D barcode symbol

is augmented with lines of text that both identify the symbol, and also report

graded measurement parameters obtained from it.

2D PQA Reporting

Honeywell' 2D PQA reporting can be enabled in two different modes: Full

Report or Screening. (To see displayed results, Microsoft® Notepad, a word

processor/editing program, or Quick*View (page 11-5) is recommended.)

If you are using Quick*View, you can enable Full Report, a listing of all of a sym-

bol's identifying information, measurements, and corresponding grades, by typ-

ing the following menu command:

2D_PQA1

or by scanning the following barcode:

Note: The PQA report is sent out as a second data/beep sequence after the

barcode data. The report has its own Honeywell code ID of >(0X3E) so

it can be uniquely identified.

* Off

Full Report