User's Manual

NAUTIZ X4 Manual
51 handheld
If enabled
- Turn on LED for good/bad scan
indicator
Bad read
Set vibration time after
bad read.
Wedge
Barcode ID
Transmit Barcode ID
Enable to transmit predefined barcode
ID in Detail tab
Label
Prefix
Enter Prefix to be sent prior to the
decoded/received data.
Suffix
Enter Suffix to be sent after the
decoded/received data
Symbologies
Select barcode types you want to read
There is “Enable All” and “Disable All” to enable/disable all symbologies
Tab
Section
Option
Description
Details
Specifies or enable available
detail settings in
symbologies
Enable this code
Tap/enable this checkbox to enable the
selected bar code type.
Barcode ID
Enter the desired features you wish to
transmit as bar code ID
Length
Set the minimum and maximum lengths
from the pull-down lists. If the numbers
are the same, acceptable bar codes will
only be that length. Not all types will
have this option enabled.
Redundancy(N4313 device
only)
If you are encountering errors when
reading some bar codes, you may want
to adjust the redundancy count.
Redundancy adjusts the number of
times a bar code is decoded before
transmission, which may reduce the
number of errors. Note that the higher
the redundancy count, the longer it will
take to decode the bar code
About
Specifies Barcode engine type, Firmware revision, Decider revision, API revision
Load Factory Default
After modifying the current settings, if
you wish to return to the factory
defaults, tap the Load Factory Default
button.