User's Manual

NAUTIZ X4 Manual
30 handheld
Factory Reset
CAUTION: To prevent data loss, back up all user data to an SD card or external memory device before performing
an upgrade or factory reset.
To Perform a Factory Reset:
1. Perform a Hard Reset
2. The terminal will reboot automatically and you will see first booting screen
3. Press “1277” when version information is displayed and then you will enter bootloader menu.
4. Press “12” to perform a factory reset.
5. When the clean boot is completed, do a touch calibration.
4.21.
Suspend Mode
Suspend Mode suspends terminal operation. The terminal appears to be “off” when in Suspend Mode. The terminal is
programmed to go into Suspend Mode automatically when inactive for a specified period of time. You can set this time
period in the Power setting.
To suspend and resume operation, press the Power button. You may also press the front Scan key to wake a suspended
device unless the battery door has been removed and replaced.
☞NOTE: You should always put the terminal in Suspend Mode when you change the battery pack; see Changing the Battery Pack on paragraph
4.18.
Troubleshooting Suspend/Resume
If the terminal does not wake when you press the Power button, the main battery might be too low to resume operation. To
check, remove the battery and install a fully charged battery or connect the terminal to a Handy Terminal charging
peripheral.
4.22.
Memory Allocation
You can verify file storage and program memory in System Properties.
1. Tap Start -> Settings -> System -> Memory tab.
4.23.
Care and Cleaning of the Products
When needed, clean the image engine window and the LCD display with a clean, non-abrasive, lint-free cloth. The terminal
can be cleaned with a damp cloth.