User's Manual

NAUTIZ X8 MANUAL
26 handheld
To Perform a Hard Reset:
1. Press the Power button for 3 seconds and choose the Hard Reset on the power menu.
2. When the reset is complete, the Desktop appears.
To perform a Hard Reset if the terminal has stopped responding, press and hold the Power button for 8 seconds
until the terminal starts to re-boot.
Factory Reset
CAUTION: To prevent data loss, back up all user data to an SD card or external memory device before
performing an upgrade or factory reset.
To Perform a Factory Reset:
1. Perform a Hard Reset
2. The terminal will reboot automatically and you will see first booting screen
3. Press “1277” when version information is displayed and then you will enter bootloader menu.
4. Press “12” to perform a factory reset.
5 When the clean boot is completed, do a touch calibration.
4.20. Suspend Mode
Suspend Mode suspends terminal operation. The terminal appears to be “off” when in Suspend Mode. The
terminal is programmed to go into Suspend Mode automatically when inactive for a specified period of time. You
can set this time period in the Power setting.
To suspend and resume operation, press the Power button.
NOTE: You should always put the terminal in Suspend Mode when you change the battery pack; see Changing
the Battery Pack on paragraph 4.18.
Troubleshooting Suspend/Resume
If the terminal does not wake when you press the Power button, the main battery might be too low to resume
operation. To check, remove the battery and install a fully charged battery or connect the terminal to a Terminal
charging peripheral.
4.21. Memory Allocation
You can verify file storage and program memory in System Properties.
1. Tap Start -> Settings -> System -> Memory tab.