User Manual

Ver 1.0

DECLARATION OF CONFORMITY

The CE symbol on your product indicates that it is in compliance with the directives of the Union European

(EU). A Certificate of Compliance is available by contacting Technical Support.

This product has passed the CE test for environmental specifications when shielded cables are used for

external wiring. We recommend the use of shielded cables.

FCC

RF Exposure Information (SAR)

This device meets the government’s requirements for exposure to radio waves. This device is designed and

manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the

Federal Communications Commission of the U.S. Government. The exposure standard employs a unit of

measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg.

Tests for SAR are conducted using standard operating positions accepted by the FCC with the EUT

transmitting at the specified power level in different channels. The FCC has granted an Equipment

Authorization for this device with all reported SAR levels evaluated as in compliance with the FCC RF

exposure guidelines. SAR information on this device is on file with the FCC and can be found under the

Display Grant section of www.fcc.gov/eot/ea/fccid . To ensure that RF exposure levels remain at or below the

tested levels, use a belt clip, holster, or similar accessory that have no metallic component in the assembly

and must maintains a minimum separation distance of 10mm between your body and the device.

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to

operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference and

(2) This device must accept any interference received, including interference that may cause undesired

operation.