User Manual

Version1.0 

11 USB
AdedicatedA‐typeUSBhostportisavailableonthedevice.Thefollowingtypesof
USBdevicesmaybeconnectedtoit.
 USBstoragedeviceslikediskdrives&pendrives
 USBkeyboardorUSBmouse
TheuserneedtoconnecttheUSBperipheralsthroughUSBhostportinrightsidepanel
showninFigure12.1,”USBHostPort”.



FIGURE12.1.USBHOSTPORT
OnceUSBperipheralisconnected,theuserneedstoenabletheUSBhostmodetouseUSB
peripherals.
12 REPLACINGHOTSWAPPABLEBATTERY 
TheALGIZRT10supportshot‐swappingofbatteries,meaningthetabletdoesn’t
needtobepoweredoffinordertoreplacethemainbattery.Tosupportsuch
mechanism,thereisabackupbatteryinsidethetabletthatischargedupwiththe
mainbattery.Thisbackupbatterycannotberemoved,and
needstohaveadequate
powerforhotswappingofmainbatterytobedonewithoutissue.Whenthebackup
batteryisfullycharged,itcansustainupto2minutesofruntimetoallowforbattery
hot‐swapping.
Performthefollowingtohotswapthebatteries:
1.RemovetheBatterycover
2.RedLEDStartsBlinkingIndicatingthattheHotswapModeisturned ON
3.OnceLEDTurnedintoSolidREDthenremovethemainbattery
4.Insertanewchargedupremovablebatteryintothebattery compartment
5.NowClosetheBatterycoverandUsetheTablet.

