User Guide

Programming the Scanner
3-7
Program & End
Scan
“
PROGRAM
”
Scanner enters programming mode,
and inhibits all non-programming functions.
Scan
“
END
”
Scanner exits programming mode, and stores all
parameters in Flash Memory ASIC or non-volatile memory,
then issues the completion beep (
3 short beeps
).
Please note that the scanner will take 3-4 seconds to store
parameters in internal Flash Memory ASIC or non-volatile
memory after you scan the “END.” Please do not turn off
the power before the completion beep. It may destroy all
configured parameters.
System List & Master Default
Scan “
M_DEFAULT
”
Scanner returns all programmable
parameters to factory preset configurations,
then issues the completion beep (
3 short beeps
).
Scan “
SYSLIST
”
Scanner lists the product information and
revision number to host via selected host interface,
then issues the completion beep (
3 short beeps
).