User Guide

Programming the Scanner
3-32
Condensed Data Editor
♦ Preamble, Postamble, Data Length & Symbol ID Trans. ♦
PROGRAM END(Exit)
Family Code Selection Parameter Selection Option Code
Preamble
None 
1-15 characters (use hex value for each character)
Maximum 15-character input; scan “FIN” to terminate this selection.
FIN
[00-7F], [FIN]
Postamble
None 
1-15 characters (use hex value for each character)
Maximum 15-character input; scan “FIN” to terminate this selection.
FIN
[00-7F], [FIN]
Data Length Transmission
Disable 
Enable 2-digits data length transmission
If data length exceeds 99, 3-digit data length will be transmitted.
0
1
Code ID Transmission
Disable Code ID transmission 
Enable prefix Code ID transmission
Enable suffix Code ID transmission
Enable both prefix and suffix Code ID transmission
0
1
2
3
Data Pass Control
Disable (format match required) 
Enable (format match not required)
If data verifier is false, the original scanned bar code data will be transmitted.
0
1
 The
Data Editor
is a very powerful, Artificial-Intelligence based data editing expert system provided specifically for the 3060B/3080B/3220 bar code scanners.
Through the
Data Editor
, you can process the scanned data prior to transmitting in many ways, such as:
Insert, Delete, Match, Verify, Replace, Reorganize
,
and
Repeat Transmission
. It also allows you to arrange the transmission of scanned data to any specific format.
 Due to the resources used by this system, the
Full-feature Data Editor
is only supported by
HHP SET
. Through
HHP SET
, all settings and configurations can be
done on-screen, under Windows
®
95/98/NT environment.
 A
Condensed Version Data Editor
is provided here in the manual and is utilized by scanning the programming bar codes.
 When Data Pass Control is disabled, all input data must conform to an edited format or the scanner does not transmit the input data to the host.