Quick Start Guide

Chapter 4 – Getting Your Device Ready

1. Make sure that your device is either connected to AC power or a battery that still has

power.

2. Press the power button to turn on your ALGIZ XRW.

1. Plug in the AC Power

2. Plug the DC power cord of the AC

adapter into the power connector of the

device

3. Plug the female end of the AC power

cord into the AC adapter and the male

end into an electrical outlet

4. Slide the power switch to boot the

system

1. Installing a Battery Pack

1. Push the latches aside to install / release the

battery to the battery compartment

Caution

Before you use your Algiz XRW, you will have to charge the battery pack. Please

fully charge the battery prior to using Algiz XRW. The new battery packs must

be 100% charged before Algiz XRW is disconnected from the external power

source. It takes a few hours to fully charge the battery when Algiz XRW is

turned off.