Installation Guide

Handi‐Treads Wood Installation



Whatyouwillneed:



●YourHandiTread(s)andincludedscrews

●Apowerdrillorascrewdriver

●Atapemeasure



1.AlignyourHandiTreadinthedesiredstairposition.Ifyouareinstallingatread,setitbackroughly½”

fromtheedge.Ifyouareinstallinganosing,makesureitfitssnuglyattheedgeofyourstair.



 



2.Startingwiththemiddlescrewholes,drillyourscrewsintothestairworkingyourwayoutfromthecenter.

Makesurethatyouaredrillingperpendiculartothesurfaceandthatyouuseallofthescrewholesprovided.

Installationiscompleteonceallscrewshavebeendrilledintoplace.Notethatthescrewholesarenot

raised;DONOTusetheraisedtractionbumpsforyourscrewplacement.



 



PAGE 1
Handi‐Treads Wood Installation What you will need: ● Your HandiTread(s) and included screws ● A power drill or a screwdriver ● A tape measure 1. Align your HandiTread in the desired stair position. If you are installing a tread, set it back roughly ½” from the edge. If you are installing a nosing, make sure it fits snugly at the edge of your stair. 2. Starting with the middle screw holes, drill your screws into the stair working your way out from the center.
PAGE 2
Handi‐Treads Concrete Installation What you will need: ● Your HandiTread ● Clear liquid silicone (OPTIONAL) ● 3/16” drive pin anchors ● 3/16” masonry drill bit ● A hammer ● A power or hammer drill We recommend using a hammer drill but a power drill will do the job. Types of Fasteners HandiTreads recommends using drive pins to fasten your treads to your stairs. Ensure that each drive pin is at least ¾” long. HandiTread Concrete Stair Installation 1.