Installation Guide

3. Make sure that the holes you have drilled are free of any concrete debris.
OPTIONAL: Deposit a small amount of clear silicone into each drilled hole. As the pins are
placed in their positions, the excess silicone will flow out of the hole leaving you with a
watertight seal. This measure is taken to prevent any water from collecting within the pin hole,
which might cause the concrete to fracture if it freezes and expands.
4. Place the tread back in position, making sure that each pin hole is above each drilled hole,
then place a drive pin in each of the pin holes. Starting in the center of the tread, work your way
to the outside, hammering each pin into its respective hole. Installation is complete when all of
the drive pins have been have been hammered into position.