Installation Guide

*The face of the tread is the little bit that hangs over the edge of the stair
Installation
1. Align your Handi-Tread in the desired stair position. If you are installing a tread, set it back
roughly ½” from the edge.
If you are installing a nosing, make sure it fits snugly at the edge of your stair.
2. Starting with the middle screw holes, drill your screws into the stair working your way out from
the center. Make sure that you are drilling perpendicular to the surface and that you use all of
the screw holes provided. Installation is complete once all screws have been drilled into place.
Note that the screw holes are not
raised; DO NOT use the raised traction bumps for your screw
placement.