Product Manual

3 Post Pressure Fit System - User Guide Rev: 2lst September, 2011 Page: 34
General Inspection and Maintenance
A) Each Use - To be completed by User
Prior to each use, the 3 Post Pressure Fit System and associated lift, accessories and sling (s), must be visu-
ally inspected. Refer to the lift, accessory and sling user guides for specific details regarding their inspection.
Should any of the these items below fail the inspection do not use the Pressure Fit System
Contact your local authorised dealer for service.
Visually check for the following:
The 3 post pressure fit system parts should not be loose, broken or bend.
Ensure ceiling area is rigid and without cracks, dust, grease and any slippery substance.
The Bases are on a stable, level surface and the Side Support Assemblies are secure.
The Trolley moves easily along the track.
The Top and Bottom Foot must be cleaned with wet cloth before installation in order to
remove dirt on rubber moulds. “ see cleaning rubber feet”
The Adjustment Track is placed in the correct location for transferring.
The portable lift has been inspected as outlined in it’s owners manual.
The sling (s) has been inspected as outlined in it’s owners manual.
B) Cleaning Rubber Feet Instructions:
Prior to each use, the Top and Bottom rubber feet need to cleaned with wet cloth soaked with water.
Step 1: Take the Bottom rubber foot and
wipe off the dirt with a wet cloth as shown
in picture.
Step 2: Take the Top rubber foot and wipe
off the dirt with wet cloth as shown in the
picture.
Note:
After cleaning, Make sure the rubber feet are clean and dry
with no residue of dirt or dust left on them.
Also, ensure Floor area is cleaned and free of dirt & debris.