Product Manual

3 Post Pressure Fit System - User Guide Rev: 2lst September, 2011 Page: 31
Trouble Shooting
Should problems arise with the use of the Pressure Fit System review the following chart. Find the fault and
complete the recommended solution. If the fault is not found and/or the solution does not correct the problem
contact your local authorized dealer for service immediately.
Fault Reason Recommended Solution
Visually the system is not aligned
straight.
1. Level is not working.
2. Floor is not leveled.
3. Level is damaged.
4. Post was knocked with impact.
1) Set up the post following Post Assembly
instructions. Check visually and with master
level to ensure the post is aligned straight.
Note: Never unlock the post with the track
connected
2) Check the floor with master level for flat-
ness.
3) Visually check the level is fine.
4) Dismantle the post following “Post Disas-
sembly Instructions” and set up the Post
again following “Post assembly instruct
tions”.
Note: Never unlock the post with the track
connected
If problem persists, contact your local authorized
dealer immediately
Feet are slipping after installation. 1. Feet are not cleaned.
2. Floor is not cleaned.
1) Clean the feet as per “ Cleaning Rubber Feet
Instructions”.
2) Ensure floor area is dry and free of debris .
If problem persists, contact your local authorized
dealer immediately .
Lever is not engaged with magnet. 1. Post Assembly instructions not fol-
lowed .
2. Clutch bearing function fails.
3. Lever not cleaned.
1) Press in the Ratchet and hold it. Grab the
lever and push up to the magnet label.
2) Contact local authorized dealer immediately.
3) Ensure lever is cleaned and free of grease or
dirt.
If problem persists, contact your local authorized
dealer immediately .
Pressure gauge is not in safe zone. 1. Post assembly instructions not fol-
lowed .
2. Barrel nut is loose or not secured
tightly.
3. Top plate Spring broken or bend.
1) Set up the post following post assembly In-
structions.
2) Tight the barrel nut with Flat Screw Driver.
3) Contact local authorized dealer immediately.
The Adjustable Track does not ex-
tend smoothly or doesn’t extend up
to required limit.
1. Physical damage to track.
2. Track slots are not cleaned.
1) Check for physical damage to track. If so,
contact local authorized dealer immediately.
2) Clean the track slots with cloth and wipe out
the dirt or debris. Again try extending the
tracks.
If problem persists, contact your local authorized
dealer immediately .
Trolley does not move smoothly
along the adjustable track.
1. Physical damage to track or trolley
wheels.
2. Track slots or trolley wheels are not
cleaned.
1) visually make sure tracks and wheels are fine
and are free of obstacles.
2) Ensure that tracks are cleaned with cloth and
free of dirt.
If problem persists, contact local authorized
dealer immediately.