User's Manual

AP-500 Wireless Outdoor
AP
Page 22 of 47
3) SNMP Community
SNMP Community name is a string for administrator to read and write the SNMP MIB
from external SNMP manager. The default SNMP community name is “public” for read
community, and “private” for write community. You may change the community name as
your plan. Confirm your setup then clicking “Save” button to perform.
4) System Name & Location
The fields of System Name and System Location is the strings for you to conveniently
identify the different unit. The content of the string is empty by default and can be any
ASCII characters with max. length of 255 characters for both System Name and System
Location. Confirm your setup then clicking “Save” button to perform.
5) ICMP Echo
The Outdoor WLAN Product normally may respond ping (ICMP Echo) request. However,
the ping response may be disabled for special purposes. Thus, the PC in this network
won't be able to probe the existence of Outdoor WLAN Product by ping command. The
default value is "Enable". Confirm your setup then clicking “Save” button to perform.
6) Management VLAN
The system is able to specify a VLAN identification (ID) for all management packets. The
VLAN ID can be 2-4094. And, specify 0 to disable this function. Confirm your setup then
clicking “Save” button to perform.
7) Reset to Factory Default button
Click this button to set all the parameters back to factory default value by “Reset All”
button, or all the parameters back to factory default value but keep the existing IP
setting by “Reset All, but keep IP Settings” button. This command only set the
configuration parameters to the factory default value, and the software version would be
keep in the current activate version.
Warning: The IP Address and Password will be reset if “Reset All” button selected
after reboot. Please use the default value for next login.
8) click “Reboot” button when you finish setting up for parameter changes taking effect.