HL-11N 802.
FCC Statement Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: 1. To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons. 2. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users.
Introduction The HL-11N Wireless module This module is the wireless networking device based on 802.11g/n technology and compatible for interoperability with existing 802.11b devices. This device provides 300Mbps transfer rate in wireless network. HL-11N is designed for Printer Server series, IP Camera series and Internet Video Server gives you wireless access the web and network resource without the wire.
2. Hardware Installation The following sections in this chapter describe how to install HL-11N Module 2.1. Installation Overview HL-11N wireless module is design for Wireless Gateway only. 2.2. Safety Recommendations The safety guidelines are as follows: λ Keep the board area clear and dust-free before, during, and after installation. λ Keep tools away from walk areas where you and others could fall over them.
2.4. Installing a HL-11N λ Remove the HL-11N module from its protective packaging. λ Avoiding Electrostatic Discharge Before you install the HL-11N module, ground yourself by touching a piece of metal to avoid electrostatic discharge (ESD). You should also take the following precautions to prevent damage to the HL-11N module: λ Keep the HL-11N module in its antistatic-shielded bag until you are ready to install it. λ Handle the HL-11N module by its edges.
