Installation Guide

- 6 -
2.4. Installing a HL-11N
λ Remove the HL-11N module from its protective packaging.
λ Avoiding Electrostatic Discharge
Before you install the HL-11N module, ground yourself by touching a
piece of metal to avoid electrostatic discharge (ESD). You should also
take the following precautions to prevent damage to the HL-11N
module:
λ Keep the HL-11N module in its antistatic-shielded bag until you
are ready to install it.
λ Handle the HL-11N module by its edges.
λ Ensure the connector is connected to above Model’s board tightly.