Project Ideas

STEP 7
Lay out your black steel threaded pipe nipples and fittings as shown
in the photo to the left. Assemble as follows using pipe wrenches to
adjust each pipe nipple and fitting into position as you go:
1. At each end of the 15.5” pipe nipple, attach a tee followed by a street
elbow (first-row photos)
2. Attach a 10” pipe nipple to each street elbow (second-row photos)
3. Attach a 90˚ elbow to each 10” pipe nipple (third-row photos)
4. Attach a street elbow to each 90˚ elbow (fourth-row photos)
5. Attach a 2” pipe nipple to each street elbow and to each of the two
tees. Set assembly on a flat surface and adjust 2” nipple heights until
level. Attach the four flange feet and adjust to level (fifth-row photos).
page 5 of 7
Below, top: Completed assembly
Bottom: Place the whole assembly over
the nuts on the top shelf of your bar cart.
1
2
3
4
5