Instructions / Assembly

Small Square Window
An easy and attractive way to give any wooden structure its own view on the world
1 Window Opening
1. Locate area to install window, making
sure there are no studs or braces in the
way.
2. Using template located on box, mark an
opening 16-1/2” wide by 24-3/4” high using
outside of dotted line (fig. A-1).
3. Drill 3/8” starter hole in corners. Cut
opening according to marked line (fig. A-2).
4. Place framing (LV) at top and bottom of
cutout flush with opening edges, nail through
studs into framing ends.
5. Position window in opening from outside
the building. Attach window using four 3/4”
screws (fig. B).
2 Window & Trim Installation
2. Position and center vertical window trim
(BQ) flush to mid-lip on the window frame.
Secure with (6) 4d finish nails. Continue with
the other side. Center trim pieces (BN) and
attach with (6) 4d finish nails per piece.
Note that the horizontal trim (BN) piece
overhangs vertical piece (BQ).
Notice: Caulk window trim (with a
quality, paintable exterior grade caulk)
along sides and across top and bottom.
LDR 06/15/06 PL
#16614
PARTS LIST
(LV) 2 Framing 2x3x22-1/2”
(BN) 2 Hor. Trim 1x3x22-1/8”
(BQ) 2 Ver. Trim 1x3x24-3/4”
1 Window
1 Hardware Kit
Part Qty. Description Size
1-800-437-0784
BQ
BQ
BN
BN
Outside View
1
2
Inside View of Wall
For 6’ wall: 3” below doubler
For 7’ wall: 12” below doubler
24-3/4”
(63cm)
16-1/2”
(42cm)
3/8” Starter holes
3/4" (1.9cm)
A
C
D
B
Inside View
LV
LV
3“ Nails
(4) 3/4” Screws; (24) Finish Nails; (8) 3” Nails