Instructions / Assembly

66
DOOR HARDWARE
Flush the stay roller bracket up underneath the vertical door trim and ush against wall panel .
Roll the door all the way over the bracket. If the door does not hit the bracket,
install bracket with 2" screws as shown in Fig. A.
If the door hits the stay roller bracket, move the bracket slightly down until the door clears the bracket
(Fig. B), then install the bracket (Fig. A).
Loosen nut and move roller until door is hanging free.
Adjust roller for best operation (Fig. C).
Tighten nut securely.
BEGIN
¸
1
2
PARTS REQUIRED:
x2
x6
#12 2" (5,1 cm)
Fig. A
Flush
Fig. B
2" (35,1 cm)
#12 Screws
Nut
D
O
O
R
Fig. C
Move bolt to adjust roller
for best operation
Move bracket
to clear bottom
of door
Flush