Installation Guide

47
2
METAL RIDGE CAP
PARTS REQUIRED:
Install 1st ridge cap ush to front of roof panels across the peak of the roof.
Foam enclosures go in-between the metal roof and the bottom edge of the ridge cap as shown.
Secure using (4) 7/8" screws 1/2" from edge of ridge cap (Fig A).
Install screws in second peak from end of ridge cap (Fig B).
Install 2nd ridge cap ush to back of roof panels, across the peak of the roof and overlapping
the installed ridge cap.
Install foam encolsures as in STEP - 1 using (8) 7/8" screws. The last foam enclosure on each end
will overlap the previous enclosures. Install screws in second peak from end of ridge cap (Fig B).
BEGIN
¸
1
Ridge Cap
4" x 4" x 54" (10,2 x 10,2 x 137,2 cm)
x2
x12
7/8" (2,2 cm)
Closure Strip 24" (61 cm)
x10
Flush
Flush
Fig. A
Closure
Strip
Ridge Cap
7/8" (2,2 cm)
Screw
FINISH
Your ridge cap are now installed.
Fig. B
Fig. B
2nd peak
from end
2nd peak
from end
1/2"
(1,3 cm)
1/2"
(1,3 cm)
From edge of ridge cap