Installation Guide

NOTE: Use a minimum of 5/8" (1,6 cm) Oriented Strand Board (OSB)
10x10'
10x18'
10x14'
4
ADDITIONAL MATERIALS
COMPLETING YOUR SHED
You will need these additional materials:
OPTIONAL MATERIALS
REFER TO THE BACK OF THIS MANUAL AND THE MANUFACTURER’S INSTRUCTIONS
FOR INSTALLATION OF SHINGLES, DRIP EDGE AND FELT.
3-TAB SHINGLES (Bundles).........
PAINT FOR SIDING (Gallons).......
Use 100% acrylic latex exterior paint.
1" galvanized roong nails (lbs).
For shingles.
Paint for trim/Quart
Use 100% acrylic latex
exterior paint.
Caulk Tubes ...........
Use acrylic paintable
latex exterior caulk.
5
2
3
10x10'
1
3
10x10'
(2) coats recommended.
Drip Edge (Feet).................................
#15 Roong Felt (Sq ft. to cover).....
1" Galvanized Roong Nails (lbs)....
For roong felt.
2" (5,1 cm)
2" (5,1 cm)
2" (5,1 cm)
x3
x2
x4
1 lb. of 2" (5,1 cm) Hot
Dipped Galvanized
Box-Type Nails.
1 lb. of 2" (5,1 cm) Hot
Dipped Galvanized
Box-Type Nails.
1 lb. of 2" (5,1 cm) Hot
Dipped Galvanized
Box-Type Nails.
5/8" x 48" x 96"
(1,6 x 121,9 x 243,8 cm)
x4
5/8" x 48" x 96"
(1,6 x 121,9 x 243,8 cm)
x6
5/8" x 48" x 96"
(1,6 x 121,9 x 243,8 cm)
x5
FLOOR PANELS (Not Included)
You will need oor panels and nails to complete your oor.
Floor panel sizes and quantities are shown below.
7
3
4
10x14'
1
4
10x14'
9
3
5
10x18'
1
5
10x18'
50
1
141
10x10'
60
196
10x14'
1.5
70
251
10x18'
2