Installation Guide

34
10-1/4"
20-1/2"
44-1/2"
48"
68-1/2"
68-1/2"
78-3/4"
92-1/2"
116-1/2"
140-1/2"
78-1/2"
44-1/2" 48" 68-1/2"
(26 cm)
(52,1 cm)
(113 cm)
(121,9 cm)
(174 cm)
(174 cm)
(200,0 cm)
(235 cm)
(295,9 cm)
(356,9 cm)
161"
(408,9 cm)
(199,4 cm)
(113 cm) (121,9 cm) (174 cm)
Fig. B
3" (7,6 cm)
Screws
Pre-Assembled Header
Install Header in
this position
Fig. A
PARTS REQUIRED:
3" (7,6 cm)
14' WALL 09
x72
2
1
BEGIN
3" (7,6 cm)
x6
STL YFA
UM UM
YFA
STL
SP
AI x5
AL x5
SP
Flush
Flush
Seam
Seam
3" (7,6 cm)
Screws
Orient parts on edge on oor as shown. Measure and mark from end of boards.
Orient Pre Assembled Header on at side (Fig. A).
Secure with (2) 3" nails at each connection and (4) 3" nails at seams.
Fasten (3) middle parts AL to Pre Assembled Header with (2) 3" screws (Fig. B).
Fasten (2) end AL to studs AI with (4) 3" nails at each side.
Secure parts AL to top plates with (2) 3" nails at each connection and (4) 3" nails at seams.
Seam
Seam
x1
Pre Assembled Header
x5
2 x 4 x 7" (5,1 x 10,2 x 17,8 cm)
AL
x2
2 x 4 x 68" (5,1 x 10,2 x 172,7 cm)
UM
x5
2 x 4 x 78-1/2" (5,1 x 10,2 x 199,4 cm)
AI
x2
2 x 4 x 48" (5,1 x 10,2 x 121,9 cm)
SP
x2
2 x 4 x 44-1/2" (5,1 x 10,2 x 113 cm)
STL
x2
2 x 4 x 68-1/2" (5,1 x 10,2 x 174 cm)
YFA
Flush