Installation Guide

62
24-3/8"
(62 cm)
24-3/8"
(62 cm)
24"
(61 cm)
24"
(61 cm)
24"
(61 cm)
DIMENSIONS ARE TO CENTER
OF RAFTERS.
DIMENSIONS ARE FROM OUTSIDE OF WALL PANELS.
24-3/8"
(62 cm)
24"
(61 cm)
24"
(61 cm)
24"
(61 cm)
24"
(61 cm)
24"
(61 cm)
24-3/8"
(62 cm)
DIMENSIONS ARE TO CENTER OF RAFTERS.
DIMENSIONS ARE FROM OUTSIDE OF WALL PANELS.
PARTS REQUIRED:
RAFTER INSTALLATION
ALIGN OVER
STUDS
ALIGN OVER
STUDS
Maintain the measurements between rafters.
Maintain the measurements between rafters.
Align rafters over the wall studs.
Check that you have the measurements shown.
Secure rafters with (2) 3" screws angled at each end (Fig. A, Fig. B).
Secure rafters on opposite side.
1
FINISH
Your rafters are now installed.
BEGIN
Rafter with
ONE GUSSET
facing inward.
Rafter with
ONE GUSSET
facing inward.
Two-Gusset
Preassembled
One-Gusset
Preassembled
3" (7,6 cm)
x6
10x14'
x2
x32
10x18'
x4
10x10'
x2
x24
Flush to
outside
of panel
Flush to
outside
of panel
Flush to
outside
of panel
Flush to
outside
of panel
Rafter with
ONE GUSSET
facing inward.
Rafter with
ONE GUSSET
facing inward.
Fig. A
3" (7,6 cm)
Screws angled
into top plate
Fig. A
3" (7,6 cm)
Screws angled
into top plate
Flush to inside
of panel
Fig. B
Flush to inside
of panel
Fig. B
10' x 10'
10' x 14'
Page 63