Installation Guide

61
x216
x20
x18
RAFTERS
10x18'
Measure 120-11/16 (306,5 cm) from the corner and install RL with (2) 3" screws.
Place two rafter-halves on oor and ush in the corners of wall and RL.
Flush rafters at peak. Secure gusset to rafters with 2" nails following the pattern shown (FIg. A).
Place two rafter-halves on oor and ush in the corners of wall and RL, as shown in STEP - 1.
Flush rafters at peak. Secure gusset to rafters with 2" nails following the pattern shown (FIg. A).
Build (2) rafter assemblies with(1) gusset (Fig. B).
Depending on your shed size, build 4 , 6 or 8 rafter assemblies with (2) gussets (Fig. C).
BEGIN
1
2
3
FINISH
Your rafters are now assembled.
Remove RL and screws from oor.
2" (5,1 cm)
PARTS REQUIRED:
x168
x120
x16
x12
x14
x10
6 x 24" (15,2 x 60,9 cm)
10x14'10x10'
Flip over rafter assembly and fasten second gusset to other side with 2" nails (FIg. C).
Temporary
Support
RL
Flush at peak
Fit base of rafters in corner
of 10' wall and RL.
SET ASIDE THESE TWO RAFTER ASSEMBLIES.
Fig. B - Build 2 Fig. C - Build 4, 6 or 8
Fig. A
1/4"
(1,9 cm)
1/4"
(1,9 cm)
Flush
Pre-assembled
Temporary Support
2 x 4 x 24" (5,1 x 10,2 x 61 cm)
x1
RL
3" (7,6 cm)
x2
120 -11/16 "
(306,5 cm)
Flush
in corner
Flush
in corner
3" (7,6 cm)
Screws
HINT:
Use oor and walls to help
assemble rafters!