Installation Guide

64
3
2
Set gable center panel on top of (2) QL,
as shown.
Measure and mark the 12" (30, cm)
center of the gable panel and
7-1/2" (19,1 cm) from bottom of panel.
Arrange trim parts as shown, with all
connections ush.
Secure with 2" nishing nails,
(2) in each part.
Turn the panel (with trim attached) over.
Secure each part with 3/4" screws
between nails, as shown.
Snip off the protruding nails.
You are nished with the
temporary supports.
Set them aside.
1
BEGIN
1
BEGIN
Your gable panel with hay loft trim is now assembled.
FINISH
2 x 4 x 39" (5,1 x 10,2 x 99,1 cm)
x2
QL
x1
2" (5,1 cm)
Finishing Nails
3" (7,6 cm)
Screws
PARTS REQUIRED:
GABLE HAY LOFT TRIM
3/4" (1,9 cm)
x20
2" (5,1 cm)
x14
Center
Temporary Support
Temporary Support
Flush all
connections
KX
x4
19/32" x 2-1/2" X 21-3/4" (1,6 x 7,6 x 55,2 cm)
x2
19/32" x 2-1/2" x 12-7/8" (1,6 x 7,6 x 32,7 cm)
JGA
x1
LKA
19/32" x 2-1/2" x 25-3/4" (1,6 x 7,6 x 65,4 cm)
12"
(30,5 mm)
7-1/2"
(19,1 mm)
12"
(30,5 mm)
QL
JGA
JGA
KX
KX
KX KX
LKA