Installation Guide

10' x 14' ROOF PANELS

PARTS REQUIRED:

48 x 96"

(121,9 x 243,8 cm)

2" (5,1 cm)

3/4" GAUGE

BLOCK

Roof panels may cause serious injury until securely fastened.

Note: Install all roof panels with the rough side up (painted grid lines).

Move to the opposite end.

Using the long edge of the panel

as a lever, move the panel side-

to-side until the top corner is

ush to the peak (Fig. B).

Move gable end rafter edge until

it is 1/2" from the 48" x 47-7/8"

roof panel (Fig. C).

Secure panel with (1) 2" nail in

each corner.

Place the 48" x 96" panel on rafters with a

3/4" measurement on the rafter (Fig A)

and the panel ush at the peak (Fig. B).

Secure panel with (1) 2" nail in each corner.

48"

x 96"

Flush at

peak

Fig. B

BEGIN

3/4"

(1,9 cm)

Gauge Block

Fig. A

Flush at

peak

Fig. B

Two

Nails

Move Gable

1/2"

(1,2 cm)

Gable

End Rafter

Fig. C

Two

Nails