Installation Guide

76
24-3/8"
(61,9 cm)
24"
(60,9 cm)
24"
(60,9 cm)
24"
(60,9 cm)
24"
(60,9 cm)
24"
(60,9 cm)
24"
(60,9 cm)
24"
(60,9 cm)
24-3/8"
(61,9 cm)
2" (5,1 cm) Nails
Fig. D
NOTE: Measurements from inside of gable panels
Install 23-7/8" x 48" roof panel
ush to the installed panel and
ush at the peak (Fig. B).
Secure panel with (1) 2" nail in
each corner (see: Fig. A).
Install 47-7/8" x 48" roof panel
ush to the installed panel and
ush at the peak (Fig. B).
Secure panel with (1) 2"
nail in each corner.
Move to the opposite end.
Using the unattached end
of the panel as a lever, move
the panel side-to-side until the
top corner is ush to the peak
(Fig. B) and there is a 3/4"
measurement on the rafter
(Fig A). Secure panel with
(1) 2" nail in each corner.
Install 2nd 47-7/8" x 48" roof panel
ush to the installed panel and ush at
the peak (Fig. B). Secure panel with (1)
2" nail in each corner.
Move gable end rafter edge until it is
1/2" from the 23-7/8" x 48" roof panel
(Fig. C).
Finish securing panel with (1) 2" nail
in each corner.
3
4
6
5
PARTS REQUIRED:
10' x 14' ROOF PANELS
x22
2" (5,1 cm)
Maintain spacing between the center of the rafters at the lower edge of the panels (Fig. D).
Secure panels with (1) 2" nail into each rafter, as shown.
Move to the top of the panel and keep spacing between the center of the rafters.
Secure panels with (1) 2" nail into each rafter.
47-7/8 x 48"
(121,6 x 121,9 cm)
x2
23-7/8 x 48"
(121,6 x 121,9 cm)
x1
Move Gable
23-7/8"
x
48"
47-7/8" x
48"
47-7/8" x
48"
Flush
Flush
Flush
Flush at
peak
Fig. B
2" nail
in each
corner
1/2"
(1,2 cm)
Gable
End Rafter
Fig. C
3/4" GAUGE
BLOCK
3/4"
(1,9 cm)
Gauge Block
Fig. A
Ensure 3/4" (1,9 cm)
before nailing.