User Manual

10
  Step 8
Repeat Steps 1 through 8, and using five hinges per
aileron, hinge the ailerons to the wing panels.
Required Parts
• Fuselage • Wheel assembly (2)
• Wheel axle (2) • Cross brace
• Wing strut tab (2) • 4-40 locknut (6)
• 4-40 setscrew (2)
• Assembled shock strut (2)
• Wheel collar w/setscrew (2)
• Main gear strut (right and left)
• 4-40 x 1/2-inch socket head screw (2)
• 4-40 x 5/8-inch socket head screw (4)
• 8-32 x 3/4-inch socket head screw (8)
• #2 x 5/8-inch sheet metal screw (8)
Required Tools and Adhesives
• Threadlock
• Hex wrench (included in kit for wheel collars)
• Phillips screwdriver (#1)
• Hex wrench: 3/32-inch, 1/8-inch
• Nut driver: 1/4-inch
Note: Be sure the 6-32 bolts that
secure the landing gear legs to the
landing brackets are snug to minimize
vibration, but allow for movement
 Step 1
Locate the left and right main gear struts and the wing
strut tab. Attach the front of the landing gear using two
8-32 x 3/4-inch socket head screws. The rear is also
secured to the fuselage using four 8-32 x 3/4-inch socket
head screws, but the wing strut tabs are positioned
between the landing gear and fuselage.
Note: Use threadlock on the
8-32 x 3/4-inch socket head screws
to prevent them from vibrating loose in flight.
Landing Gear Installation
 Step 9
Repeat Steps 1 through 8, and using three hinges, hinge
the rudder to the fin/fuselage.
Hinging the Control Surfaces