User Manual

11
Note: In Step 2, leave the screws
loose in the gear until all the struts
and cross brace are in position.
 Step 2
Use two 4-40 x 5/8-inch socket head screws and two
4-40 locknuts to attach the shock struts to the main
landing gear struts. The cross brace also uses two
4-40 x 5/8-inch socket head screws and 4-40 locknuts
to attach to the gear near the fuselage. Last, use two
4-40 x 1/2-inch socket head screws and two 4-40
locknuts to attach the shock struts to the cross brace.
  Step 3
Locate the main wheel and remove the front and rear hubs
from the wheel.
  Step 4
Secure the wheel collar to the axle by tightening
the setscrew onto the flat of the axle with the included
hex wrench.
Note: Use threadlock on the setscrew to
prevent it from vibrating loose in flight.
  Step 5
Slide the rear hub into the wheel. The rear hub is
identified as the one without the holes going through the
hub for the screws. Slide the longer portion of the axle
into the hub, then slide the front hub into the wheel.
Note: The photo does not show
the wheel to illustrate how the wheel
collar is placed between the two wheel
hubs to hide the wheel collar.
Landing Gear Installation