User Manual

12
  Step 6
The front and rear hubs will key together when
installed properly. Once installed, use four #2 x 5/8-inch
sheet metal screws to secure the hubs together. Check
the rotation of the wheel when installing the screws.
If the wheel does not rotate, loosen the screws slightly
until it does.
  Step 7
Use a 4-40 setscrew to secure the axle to the main landing
gear.
Note: Use threadlock on the setscrew to
prevent them from vibrating loose in flight.
  Step 8
To complete the wheel installation, snap the hub cap
onto the wheel.
  Step 9
Repeat Steps 3 through 8 to install the remaining wheel.
Landing Gear Installation