User Manual

17
 Step 4
Repeat steps 1 through 3 to prepare the remaining cover
while the epoxy cures.
  Step 5
Position the servo between the block and with a small
space between the servo and cover. Use a felt-tipped pen
to mark the locations for the servo mounting screws onto
the blocks.
  Step 6
Drill the marked locations using a drill and 1/16-inch
(1.5mm) drill bit. Use the hardware provided with the
servo to secure it to the blocks.
  Step 7
Use string or a commercially available connector to secure
a 18-inch (457mm) servo extension to the servo lead.
  Step 8
Tie a weight to a 24-inch (610mm) piece of string. Lower
the weight into the wing and pull it out at the opening for
the servo cover.
Aileron Servo Installation