User Manual

18
  Step 9
Tie the string to the end of the servo extension and use it
to pull the extension through the wing. Use a piece of tape
to keep the extension from falling back into the fuselage.
  Step 10
Position the servo hatch cover and secure it using four
#2 x 1/2-inch sheet metal screws. After installing the
screws, remove them and apply a few drops of thin CA to
the holes to harden the wood to prevent the screws from
vibrating loose.
  Step 11
Assemble the aileron pushrod by sliding the safety
fuel tubing onto two metal clevises. Thread the two
metal clevises and two 4-40 nuts onto a 4
3
/
4
-inch
(120mm) pushrod.
Aileron Servo Installation