User Manual

20
Required Parts
• Fuselage assembly • 4-40 nut (4)
• Metal clevis (4) • Rudder cable
• Rigging couplers (4) • Cable crimps (4)
• 2-56 nuts (3) • Rudder spring (2)
• Rudder tiller bracket • Radio tray cover
• Safety fuel tubing (4)
• Rado tray cover
• 2-56 x 5/8-inch machine screw (9)
• Hook and loop strap (2)
• #2 x 5/8-inch sheet metal screw (4)
• 33
1
/
4
-inch (845mm) elevator pushrod (2)
• 4-40 ball end w/hardware (4)
• Control horn w/backplate (4)
Required Tools and Adhesives
• Drill • Large servo arm (3)
• Threadlock • Hobby knife
• Felt-tipped pen • Thin CA
• Crimping tool/vice grips • Pliers
• 1/4-inch (6mm) foam
• Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm)
  Step 1
Locate the 33
1
/
4
-inch (845mm) elevator pushrod and a 4-
40 ball end. Thread the ball end onto one end of the rod a
minimum of 14 turns.
  Step 2
Attach the ball end to a large servo horn. Use side cutters
to remove the remaining arm from the horn.
  Step 3
Slide the pushrod into the elevator pushrod tube inside
the fuselage. You will need to trim the covering from the
pushrod exit using a hobby knife.
  Step 4
Slide a piece of safety fuel tubing onto a metal clevis.
Thread a 4-40 nut and metal clevis onto the pushrod.
Radio Installation